![]() Take your advantage > save the startup-configuration and the show version output. During the boot process you see that the license is activate. Use the command in the configuration terminal mode: activation-key copy/past the activation key from the old saved configuration ( show version )Īfter this you have to reboot the Cisco ASA. I have Cisco ASA5505 8.2 (5) connected with Cisco 5520 8.2 (1) via IPSEC tunnel, I was able to SSH from the inside 5520 to inside IP of the asa5505. ADAPTIVE SECURITY APPLIANCE ISAKMP STATES: MMWAITMSG2: Initial DH public key sent to responder. This is a good advice to do make always a copy of your show version or save the Running Activation key in your documentation. Also I got this from a Cisco TAC engineer a long time ago. I looked up in an old configuration where I had done the “ show version” command. So how to recover the security license on you cisco asa. Before the memory upgrade I had the security license. The Cisco ASA was back to it’s base License. With the following warning in the Info log: invalid. I looked in the “show version” command and saw the message below: Now, when we want to backup a running conf for an ASA 5505, this happens: ikev1 pre-shared-key. After the upgrade the cisco asa forgot the configuration (not that bad, because I had a configuration backup), however after I uploaded the startup-configuration and than I saw the following output. Today I upgraded a Cisco ASA 5505 from 256MB memory to 512MB and 128MB Flash to 256MB Flash. ![]() Disclaimer with some general information.Travel a list of my past visited countries. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |